We do have a video of the Curt Custom Fit Vehicle Wiring, part # C56026 being installed on a 2012 Captiva.
I have attached a link to the installation video you can check out. view full answer...
I have attached a picture below of the panel you will need to remove to install either the Curt T-Connector Vehicle Wiring Harness item # C56257 or the Hopkins Plug-In Simple Vehicle Wiring Harness item # HM11141304 on your 2014 Chevrolet Captiva Sport. These connectors plug into your factory wiring harness and do not require any cutting or splicing of wires. You will have to remove quite a bit of your Captiva's rear trim pieces to find the harnesses. I have linked a couple of installation... view full answer...
It sounds like you're in the process of installing the Demco SBS Stay-IN-Play Duo # SM99251 on your 2015 Chevy Captiva Sport, and there might be some confusion as to what connects to the Roadmaster Stop Light Switch Kit # RM-751476 during the process. There will be 2 wires coming from the Roadmaster Stop Light Switch-both of them are black.
When connecting the wires, you will connect one of the wires to the red wire from the LED indicator light from the Stay-IN-Play system and one will... view full answer...
For towing your 2013 Chevrolet Captiva on the Roadmaster Tow Dolly # RM-2050-1 you will want to follow the instructions in your owners manual.
1. Put the front wheels on a dolly.
2. Move the shift lever to P (Park).
3. Set the parking brake.
4. Clamp the steering wheel in a straight-ahead position with a clamping device designed for towing.
5. Remove the key from the ignition.
6. Secure the vehicle to the dolly.
7. Release the parking brake.
Note that this procedure is for front wheel... view full answer...
The Hopkins # 48955 taillight diode kit can indeed be used to drive the running /brake lights on your Captiva like a three function lamp, without using the amber bulb for a turn signal.
See the diagram I provided, and I'll also send you a copy as an email attachment. view full answer...
In the 2013 Chevy Captiva there is an in-cab fuse panel located on the driver's side in the bottom left kick panel. You will need to pull the 2 amp fuse labeled PWR/Moding which should be in the bottom right corner above another fuse labeled CIM. This information and other specific information on flat towing the Captiva can be found in the owner's manual. Use the index to find the recreational towing section.
The fuse is in an easily accessible location but you do have the option to install... view full answer...
A backup camera can be wired to any lighting circuit you want to deliver the 12V power to operate it. Many prefer to use a reverse light wire, which will activate the camera only when the vehicle is in reverse gear with its backup lights on. Other installations could use a switch to allow the camera to be turned on at will, while others may want to wire the camera to the running light circuit so that it operates any time the vehicle headlights are on.
Your clearance light can be used... view full answer...
Go To Results